Installation guide for rCell 500 dual SIM LTE

MTR5 MultiConnect rCell 500 Captive Portal Setup Guide for Hotspotsystem

Important note: This solution requires a Hotspot Operator Account at HotSpotSystem.com. You can create an Operator Account here. If you would like to see what features you will be able to use with our solutions, click here. If you already have an Operator Account, then read on...

The following setup is based on Firmware version 4.04b01.

Ensure that no timezone is configured and that the router uses GMT/UTC time.

Under Basic Network – WAN, configure your WAN for Internet access.

Under Basic Network – WiFi, configure your WiFi Access Point. For Authentication select Auto or Open and for Encryption select None.

Under Basic Network – Client/Server, create a new DHCP server.
- DHCP 2, with adifferent IP address range from DHCP 1.
- Reboot the router when prompted.

Under System – External Servers, create a UAM Server with the following settings:

  • Server Name: hotspotsystem
  • Server IP/FQDN: www.hotspotsystem.com
  • Server port: (leave blank)
  • Login URL: https://customer.hotspotsystem.com/customer/hotspotlogin.php
  • Shared Secret: hotsys123
  • NAS/Gateway ID: Operator Username used for access to the Hotspotsystem Control Center
  • Location ID: Numeric value of the Location ID created on the Hotspotsystem Control Center
  • Location name: Location Name created on the Hotspotsystem Control Center
  • Server: check Enable
  • Under System – External Servers, create a RADIUS Server with the following settings:

  • Server Name: Radius
  • Server IP/FQDN: radius.hotspotsystem.com
  • Server port: (leave blank)
  • Primary Shared Key: hotsys123
  • Primary Authentication Protocol: CHAP
  • Secondary Shared Key: hotsys123
  • Secondary Authentication Protocol: CHAP
  • Shared Secret: hotsys123
  • Server: check Enable
  • Under Applications – Captive Portal, configure the following settings:

  • Captive Portal: check Enable
  • WAN Interface: WAN1 or the WAN interface to be used by the Captive Portal
  • LAN Subnet: DHCP 2 or DHCP server created in STEP 3.
  • Authentication Server: select External RADIUS Server and the Radius server created in STEP 5.
  • UAM Server: check Enable and select the UAM server created in STEP 4.
  • Under Basic Network – LAN/VLAN, change the DHCP server for VAP 1 (or the WiFi Access Points for which you want to use the Captive Portal) to DHCP 2 (or the DHCP server created in STEP 3).

    Reboot to make sure that settings persist and test your new Hotspotsystem Captive Portal.

    Note: Multitech will support the device, customers who have purchased the device can go onto Multitech Support Site to log support requests and can also send queries directly to them at support at 3g.co.za

    Setup a hotspot today! No credit card required.
      Sign up for free
    Choose your language:
    ©2006-2024 HotspotSystem, Inc. All Rights Reserved.
    Webdesign